东芝投影机-TDP-FF1AU说明书.pdf-资料库

第1页 / 共47页

第2页 / 共47页

第3页 / 共47页

第4页 / 共47页

第5页 / 共47页

第6页 / 共47页

第7页 / 共47页

第8页 / 共47页

OWNER'S MANUAL LED PROJECTOR TDP-FF1A i g n s U e r o f e B s n o i t a r a p e r P s n o i t a r e p O s r e h t O

SAFETY PRECAUTIONS The lightning ﬂash with arrowhead symbol, within an equilateral triangle, is in- tended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufﬁcient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS AP- PLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLT AGES ARE PRESENT IN- SIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALI- FIED PERSONNEL ONLY. WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a chemical known to the State of USA only California to cause birth defects or other reproductive harm. Wash hands af- ter handling. MODEL NAME: TDP-FF1 USA only TRADE NAME: LED PROJECTOR MODEL NAME: TDP-FF1 Tested To Comply With FCC Standards FOR HOME OR OFFICE USE FCC NOTICE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener- ates, uses and can radiate radio frequency energy and, if not installed and used in ac- cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 2

- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. RESPONSIBLE PARTY: TOSHIBA AMERICA INFORMATION SYSTEMS, INC. 9740 Irvine Blvd., Irvine, CA 92618-1697 U.S.A Phone: (949) 583-3000 g n i s U e r o f e B WARNING: Changes or modiﬁcations made to this equipment, not expressly approved by USA only Toshiba, or parties authorized by Toshiba, could void the user’s authority to operate the equipment. WARNING: This Class B digital apparatus complies with Canadian ICES-003. Cet appareil CANADA only numérique de la classe B est conforme à la norme NMB-003 du Canada. CAUTION LED RADIATION DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS. CLASS 2M LED PRODUCT. MANUF ACTURED SERIAL NO. 3

IMPORTANT SAFETY INSTRUCTIONS CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUC- TIONS GIVEN IN THIS OWNER’S MANUAL AND THOSE MARKED ON THE UNIT. RETAIN THIS BOOKLET FOR FUTURE REFER- ENCE. This set has been designed and manufactured to assure personal safety. Improper use can result in electric shock or ﬁre hazard. The safeguards incorporated in this unit will protect you if you observe the following procedures for installation, use and servicing. This unit is fully transistorized and does not contain any parts that can be repaired by the user. DO NOT REMOVE THE CABINET COVER, OR YOU MAY BE EXPOSED TO DANGEROUS VOLTAGE. REFER SERVICING TO QUALIFIED SERVICE PER- SONNEL ONLY. 1. Read Owner’s Manual After unpacking this product, read the owner’s manual carefully, and follow all the operating and other instructions. 3. Source of Light Do not look into the lens while the machine is on. The strong light from the len may cause damage to your eyes or sight. 2. Power Sources This product should be operated only from the power source indi- cated on the marking label. If you are not sure of the type of power supply to your home, con- sult your product dealer or local power company. For products intended to oper- ate from battery power, or other sources, refer to the operating instructions. 4. Ventilation Openings in the cabinet are pro- vided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to. 4

5. Heat The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including ampli- ﬁers) that produce heat. 8. Power-Cord Protection Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, pay- ing particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. g n i s U e r o f e B 9. Overloading Do not overload outlets; extension cords, or integral convenience receptacles as this can result in a risk of ﬁre or electric shock. 6. Water and Moisture Do not use this product near water. For example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swim- ming pool and the like. 7. Cleaning Unplug this product from the outlet before cleaning. Use a soft cloth in- stead of liquid cleaners or aerosol cleaners for cleaning. 5

IMPORTANT SAFETY INSTRUCTIONS (continued) 10. Lightning storms For added protection for this prod- uct during storm, or when it is left unattended and unused for long periods of time, unplug it from the outlet. This will prevent damage to the product due to lightning and power-line surges. However, while it is thundering or lightning, do not touch the apparatus and any connected cable and/or equip- ment. This will prevent you from receiving the electric shock by an electric surge. 11. Object and Liquid Entry Never push objects of any kind into this product through open- ings as they may touch dangerous voltage points or short-out parts that could result in a ﬁre or elec- tric shock. Never spill liquid of any kind on the product. 12. Do not place the product vertically Do not use the product in the upright position to project the pic- tures at the ceiling, or any other vertical positions. It may fall down and be dangerous. 13. Stack Inhibited Do not stack other equipment on this product or do not place this product on the other equipment. Top and bottom plates of this product develops heat and may give some undesirable damage to other unit. 14. Attachments Do not use attachments not recommended by the product manufacturer as they may cause hazards. 6

15. Accessories Do not place this product on an unstable cart, stand, tripod, brack- et, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn. g n i s U e r o f e B e) If the product has been dropped or damaged in any way. f) When the product exhibits a dis- tinct change in performance - this indicates a need for service. 17. If glass components, in- cluding lens, should break, contact your dealer for repair service. This product incorporates glass components, including a lens. If such parts break, please handle with care to avoid injury and con- tact your dealer for repair service. The broken pieces of glass may cause to injury. S3125A 18. Servicing 16. Damage Requiring Service Unplug this product from the out- let and refer servicing to qualiﬁed service personnel under the fol- lowing conditions: a) When the power-supply cord or plug is damaged. b) If liquid has been spilled, or ob- jects have fallen into the product. c) If the product has been exposed to rain or water. d) If the product does not operate normally by following the operat- ing instructions. Adjust only those controls that are covered by the operating instructions as an im- proper adjustment of other con- trols may result in damage and will often require extensive work by a qualiﬁed technician to restore the product to its normal operation. Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other haz- ards. Refer all servicing to quali- ﬁed service personnel. 7

IMPORTANT SAFETY INSTRUCTIONS (continued) 22. Do not use the product in 19. Replacement Parts a closed installation state. Do not place the product in a box or in any other closed installation state. Otherwise it may overheat. This could result in a risk of ﬁre. When replacement parts are re- quired, be sure the service techni- cian has used replacement parts speciﬁed by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in ﬁre, electric shock, or other hazards. 20. Safety Check Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 21. Do not leave thermalpaper documents or easily de- formed items on top of the unit or near the air exhaust for long periods of time. The heat from the unit could erase the information on the thermal paper, or cause deformation or warping. 8

资料库

东芝投影机-TDP-FF1AU说明书.pdf

相关推荐

投影机

热门标签

最新资料