ISO15118-3-2015 电动汽车与充电设施通信.pdf

发布时间：2022-06-14 发布人：admin 分类：说明书资料大小：3.50M 资料格式：pdf 举报版权申诉

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第1页.png

第1页 / 共91页

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第2页.png

第2页 / 共91页

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第3页.png

第3页 / 共91页

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第4页.png

第4页 / 共91页

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第5页.png

第5页 / 共91页

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第6页.png

第6页 / 共91页

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第7页.png

第7页 / 共91页

5e1a8f88-5954-49a2-8732-96609d4a14ff.pdf-第8页.png

第8页 / 共91页

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Symbols and abbreviated terms

5 Conventions

5.1 Definition of OSI based services

5.2 Requirement structure

5.3 Normative references convention

6 System architecture

6.1 Communication layers overview

6.2 Definition of high-level communication and basic signalling

6.2.1 Basic signalling

6.2.2 High-level communication

6.3 Identification requirements

6.4 System requirements

6.4.1 Overview

6.4.2 EVSE

6.4.3 EV

6.5 Configuration of a low-layer communication module

7 Connection coordination

7.1 General

7.2 Overview

7.3 Plug-in phase

7.3.1 EVSE side

7.3.2 EV side

7.4 Initialization phase

7.5 Loss of communication

7.5.1 EVSE side

7.5.2 EV side

7.6 Sleep mode and wake-up

7.6.1 Entering the sleep mode

7.6.2 Wake-up

7.6.3 During a charge pause

7.7 Plug-out phase

8 Timings and constants

9 Matching EV — EVSE process

9.1 Overview

9.2 Initialization of matching process

9.3 Discovery of the connected low-layer communication module

9.4 Validation of matching decision

9.5 Set-up a logical network

9.6 Leave the logical network

9.7 Error handling

10 EMC requirements

11 Signal coupling

12 Layer€2 interfaces

12.1 Overview

12.2 Data SAP

12.3 Data link control SAP to layer€3

Annex€A (normative) HomePlug Green PHY on control pilot line

Annex€B (informative) IEEE€1901.2 G3-PLC profile on control pilot line

Bibliography

BS ISO 15118-3:2015 BSI Standards Publication Road vehicles — Vehicle to grid communication interface Part 3: Physical and data link layer requirements British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

BS ISO 15118-3:2015 BRITISH STANDARD National foreword This British Standard is the UK implementation of ISO 15118-3:2015. The UK participation in its preparation was entrusted to Technical Committee AUE/16, Data Communication (Road Vehicles). A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. © The British Standards Institution 2015. Published by BSI Standards Limited 2015 ISBN 978 0 580 75445 6 ICS 43.120 Compliance with a British Standard cannot confer immunity from legal obligations. This British Standard was published under the authority of the Standards Policy and Strategy Committee on 30 June 2015. Amendments issued since publication Date Text affected British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

INTERNATIONAL STANDARD BS ISO 15118-3:2015 ISO 15118-3 First edition 2015-05-15 Part 3: Road vehicles — Vehicle to grid communication interface — Physical and data link layer requirements Véhicules routiers — Interface de communication entre véhicule et réseau électrique — Partie 3: Exigences relatives à la couche physique et à la couche liaison de données Reference number ISO 15118-3:2015(E) © ISO 2015 British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

BS ISO 15118-3:2015 ISO 15118-3:2015(E) COPYRIGHT PROTECTED DOCUMENT © ISO 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 • CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org ii © ISO 2015 – All rights reserved British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

BS ISO 15118-3:2015 ISO 15118-3:2015(E) 1 2 3 4 5 6 7 8 9 Contents Page Foreword ..........................................................................................................................................................................................................................................v Introduction ................................................................................................................................................................................................................................vi Scope .................................................................................................................................................................................................................................1 Normative references ......................................................................................................................................................................................1 Terms and definitions .....................................................................................................................................................................................1 Symbols and abbreviated terms ...........................................................................................................................................................4 Conventions ...............................................................................................................................................................................................................5 5.1 Definition of OSI based services ...............................................................................................................................................5 5.2 Requirement structure .....................................................................................................................................................................5 5.3 Normative references convention ..........................................................................................................................................5 System architecture ...........................................................................................................................................................................................6 6.1 Communication layers overview .............................................................................................................................................6 6.2 Definition of high-level communication and basic signalling .........................................................................7 Basic signalling ..................................................................................................................................................................7 6.2.1 6.2.2 High-level communication ......................................................................................................................................7 6.3 Identification requirements.........................................................................................................................................................8 6.4 System requirements .........................................................................................................................................................................8 Overview .................................................................................................................................................................................8 6.4.1 6.4.2 EVSE ............................................................................................................................................................................................8 6.4.3 EV ..................................................................................................................................................................................................9 6.5 Configuration of a low-layer communication module .......................................................................................10 Connection coordination ..........................................................................................................................................................................10 General ........................................................................................................................................................................................................10 7.1 7.2 Overview ...................................................................................................................................................................................................10 Plug-in phase .........................................................................................................................................................................................17 7.3 EVSE side .............................................................................................................................................................................17 7.3.1 7.3.2 EV side ...................................................................................................................................................................................17 7.4 Initialization phase ...........................................................................................................................................................................17 7.5 Loss of communication .................................................................................................................................................................18 EVSE side .............................................................................................................................................................................18 7.5.1 7.5.2 EV side ...................................................................................................................................................................................18 7.6 Sleep mode and wake-up ............................................................................................................................................................19 7.6.1 Entering the sleep mode ........................................................................................................................................19 7.6.2 Wake-up................................................................................................................................................................................19 7.6.3 During a charge pause ..............................................................................................................................................20 7.7 Plug-out phase ......................................................................................................................................................................................20 Timings and constants.................................................................................................................................................................................21 Matching EV — EVSE process ................................................................................................................................................................22 Overview ...................................................................................................................................................................................................22 9.1 Initialization of matching process .......................................................................................................................................24 9.2 Discovery of the connected low-layer communication module.................................................................24 9.3 9.4 Validation of matching decision ............................................................................................................................................25 9.5 Set-up a logical network ..............................................................................................................................................................27 9.6 Leave the logical network ...........................................................................................................................................................27 9.7 Error handling ......................................................................................................................................................................................27 EMC requirements ...........................................................................................................................................................................................27 Signal coupling ....................................................................................................................................................................................................27 Layer 2 interfaces..............................................................................................................................................................................................28 12.1 Overview ...................................................................................................................................................................................................28 iii © ISO 2015 – All rights reserved 10 11 12 British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

BS ISO 15118-3:2015 ISO 15118-3:2015(E) 12.2 Data SAP .....................................................................................................................................................................................................28 12.3 Data link control SAP to layer 3 .............................................................................................................................................28 Annex A (normative) HomePlug Green PHY on control pilot line ......................................................................................30 Annex B (informative) IEEE 1901.2 G3-PLC profile on control pilot line.....................................................................72 Bibliography .............................................................................................................................................................................................................................79 iv © ISO 2015 – All rights reserved British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

BS ISO 15118-3:2015 ISO 15118-3:2015(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this document and those intended for its further maintenance are described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives). Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents). Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement. For an explanation on the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO’s adherence to the WTO principles in the Technical Barriers to Trade (TBT) see the following URL: Foreword - Supplementary information The committee responsible for this document is ISO/TC 22, Road vehicles, Subcommittee SC 31, Data communication. ISO 15118 consists of the following parts, under the general title Road vehicles — Vehicle to grid communication interface: — Part 1: General information and use-case definition — Part 2: Network and application protocol requirements — Part 3: Physical layer and Data Link Layer requirements The following parts are under preparation: — Part 4: Network and application protocol conformance test — Part 5: Physical layer and data link layer conformance test — Part 6: General information and use-case definition for wireless communication — Part 7: Network and application protocol requirements for wireless communication — Part 8: Physical layer and data link layer requirements for wireless communication © ISO 2015 – All rights reserved v British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

BS ISO 15118-3:2015 ISO 15118-3:2015(E) Introduction The pending energy crisis and the necessity to reduce greenhouse gas emissions has led the vehicle manufacturers to a very significant effort to reduce the energy consumption of their vehicles. They are presently developing vehicles partly or completly propelled by electric energy. Thus, vehicles will reduce the dependency on oil, improve the global energy efficiency, and reduce the total CO2 emissions for road transportation if the electricity is produced from renewable sources. To charge the batteries of such vehicles, specific charging infrastructure is required. Much of the standardization work on dimensional and electrical specifications of the charging infrastructure and the vehicle interface is already treated in the relevant ISO or IEC groups. However, the question of information transfer between the vehicle and the grid has not been treated sufficiently. Such communication is beneficial for the optimization of energy resources and energy production systems as vehicles can recharge at the most economic or most energy-efficient instants. It is also required to develop efficient and convenient payment systems in order to cover the resulting micro-payments. The necessary communication channel might serve in the future to contribute to the stabilization of the electrical grid, as well as to support additional information services required to operate electric vehicles efficiently. vi © ISO 2015 – All rights reserved British Standards InstitutionProvided by IHS under license with BSI - Uncontrolled Copy Licensee=Chongqing Institute of quality and Standardization 5990390Not for Resale, 2015/8/28 00:53:53 No reproduction or networking permitted without license from IHS--`,``,``,``,,```````,``,-`-``,```,,,`---

分享到：

赞收藏

资料库

ISO15118-3-2015 电动汽车与充电设施通信.pdf

相关推荐

开发技术

热门标签

最新资料