FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired op-
eration
Note: This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
E
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If
such changes or modifications should be made, you could be required to stop operation of the equipment.
1
TRADEMARK INFORMATION
Microsoft® and Windows® are U.S. registered trademarks of Microsoft Corporation.
Pentium® is a registered trademark of Intel Corporation.
Macintosh is a trademark of Apple Computer, Inc.
SD™ is a trademark.
PhotoSuite, PhotoVista and the MGI logo are trademarks or registered trademarks of MGI Soft-
ware Corp.
E
Adobe, the Adobe logo, and Acrobat are trademarks of Adobe Systems Incorporated.
Other names and products may be trademarks or registered trademarks of their respective owners.
READ THIS FIRST
Please start by reading the important messages below first.
1. The bundled driver, software, design, specifications and user’s manual that packaged with the
camera are subject to change without notice.
2. The accessories that come with the camera may vary between regions.
3. For driver update, you can contact the dealer who you purchased the camera from for help.
4. We are not liable whatsoever for any compensation arising from errors in descriptions in this
user’s manual.
2
WARNINGS
Do not use the camera if it is emitting smoke, becomes unusually hot to be touched, emitting any unusual odor or
noise, or if it is in any other abnormal states. Operating the camera in any of these situations may cause a fire or
an electrical shock. Stop using the camera immediately, turn the camera off, and then disconnect the power
source (batteries or AC power adapter). (If you are using the AC power adapter, unplug the adapter from the AC
power outlet after you have disconnected the camera.) After checking that smoke is no longer being emitted,
contact your dealer or your local authorized service facility and request repairs. Never attempt to repair the cam-
era yourself as this is dangerous.
Do not use the camera if any foreign objects have entered the camera. Turn the camera off, and then disconnect
the power source (batteries or AC power adapter). (If you are using the AC power adapter, unplug the adapter
from the AC power outlet after you have disconnected the camera.) Then contact your dealer or your local autho-
rized service facility. Do not continue to use the camera as this may cause a fire or an electrical shock.
If the camera has been dropped or if the camera case has been damaged, turn the camera off, and then discon-
nect the power source (batteries or AC power adapter). (If you are using the AC power adapter, unplug the
adapter from the AC power outlet after you have disconnected the camera.) Then contact your dealer or your local
authorized service facility. Do not continue to use the camera as this may cause a fire or an electrical shock.
Do not place the camera in any unstable locations such as on a wobbly table or sloping surface where the camera
E
may fall or tip over and cause injury.
Do not expose the camera to moisture and make sure that there is no water getting into the camera. Take particular
care when using the camera under extreme weather conditions such as rain or snow, or when operating the
camera at the beach on near water. Water in the camera may cause a fire or an electrical shock.
Do not attempt to modify the camera. This may cause a fire or an electrical shock.
Do not remove the camera casing. This may cause an electrical shock. Internal inspection, maintenance and
repairs should only be carried out by your dealer or local authorized service facility.
Do not touch the power plug during a thunderstorm if you are using the AC power adapter. This may cause an
electrical shock.
3
CAUTIONS
Do not place the camera in damp or dusty locations. This may cause a fire or an electrical shock.
Do not place the camera in a location affected by oil fumes or steam, such as near a cooking stove or humidifier.
This may cause a fire or an electrical shock.
Exposure to high temperatures may adversely affect the camera case and internal components and may cause a
fire.
Do not cover or wrap the camera or the AC power adapter with a cloth or quilt. This may cause heat to build up
E
and distort the case and cause a fire. Always use the camera and its accessories in well-ventilated locations.
Handle the camera carefully and do not bump the camera into any hard object. Handling the camera roughly may
cause a malfunction.
Do not move the camera while it is switched on. (If you are using the AC power adapter, unplug the adapter from
the AC power outlet after you have switched off the camera.) Ensure that any connector cords or cables to other
devices are disconnected before moving the camera. Failure to do so may damage the cords or cables and cause
a fire or an electrical shock.
When leaving the camera unused for long periods, such as during a vacation, always unplug the camera from the
power source (batteries or AC power adapter) for safety. (if you are using the AC power adapter, unplug the
adapter from the AC power outlet after you have disconnected the camera.) Failure to do so could result in a fire.
Do not use batteries other than those specified for use with the camera. The use of unsuitable batteries may result
in the batteries splitting or leaking and causing a fire, injury, or soiling of the battery compartment.
When fitting batteries into the camera, check the polarity markings on the battery (- and +) to ensure that you
insert the battery correctly. Incorrect battery polarity may result in the batteries splitting or leaking and causing a
fire, injury, or soiling of the battery compartment.
Remove the batteries if the camera will not be used for an extended period of time. The batteries may leak and
cause a fire, injury or soiling of the battery compartment. If the batteries leak, clean and wipe the battery compart-
ment carefully and install new batteries. Wash your hands carefully if you touch the battery fluid.
4
CONTENTS
INTRODUCTION........................... 8
Overview ............................................. 8
Package contents ............................... 9
Optional accessories .......................... 9
GETTING TO KNOW THE
CAMERA ...................................... 10
Front view ............................................ 10
Rear view ............................................ 11
Mode dial ............................................ 12
LED indicators..................................... 13
Status LCD .......................................... 14
LCD monitor indicators ....................... 15
GETTING STARTED .................... 17
Installing the batteries ......................... 17
Using the AC power adapter .............. 18
Loading a SD memory card ................ 19
Attaching the strap.............................. 20
Choosing the language....................... 21
Setting the date and time .................... 22
Setting the image resolution
and quality .......................................... 23
RECORD MODE ........................... 25
Taking pictures .................................... 25
Using the viewfinder ................................. 25
Using the LCD monitor .............................. 26
Reviewing the last picture
in the record mode .............................. 27
Using the optical zoom ....................... 28
Using the digital zoom ........................ 29
Using the self-timer ............................. 30
Using the macro mode ....................... 31
Using the flash .................................... 32
Taking pictures manually .................... 34
PLAYBACK MODE ....................... 35
Viewing images ................................... 35
Zooming images in and out ................ 36
Displaying thumbnail images.............. 37
Slideshow display ............................... 38
E
5
E
Deleting images .................................. 39
MOVIE MODE ............................... 40
Recording video clips ......................... 40
Viewing video clips ............................. 41
TRANSFERRING RECORDED
IMAGES TO YOUR
COMPUTER.................................. 42
Step 1: Installing the USB driver
on windows computers ....................... 43
Installing the USB driver on
macintosh computer ........................... 43
Step 2: Connecting the camera
to your computer ................................. 44
Step 3: Downloading images .............. 45
Windows computers ................................. 45
Macintosh computers ............................... 45
INSTALLING MGI PHOTOSUITE .. 46
INSTALLING MGI PHOTOVISTA .. 47
6
INSTALLING ACROBAT
READER ....................................... 48
USING THE USER’S MANUAL.... 49
MENU OPTIONS .......................... 50
Record menu ...................................... 50
LCD BRIGHTNESS .................................... 50
QUICKVIEW .............................................. 50
DIGITAL ZOOM ......................................... 51
EXIT ........................................................... 51
Manual record menu ........................... 52
LCD BRIGHTNESS .................................... 52
QUICKVIEW .............................................. 52
DIGITAL ZOOM ......................................... 52
WHITE BALANCE ...................................... 53
EV COMPENSATION ................................. 54
SHARPNESS ............................................. 55
EXIT ........................................................... 55
Playback menu ................................... 56
LCD BRIGHTNESS .................................... 56
SLIDE SHOW ............................................ 56
COPY TO CARD ........................................ 56
DPOF ......................................................... 57
EXIT ........................................................... 58
Movie menu......................................... 59
LCD BRIGHTNESS .................................... 59
EXIT ........................................................... 59
Setup menu ......................................... 60
DATE/TIME ................................................ 60
LANGUAGE .............................................. 60
SOUND ..................................................... 61
FORMAT MEDIA ........................................ 61
VIDEO MODE ............................................ 61
AUTO POWER OFF ................................... 62
RESET TO DEFAULT ................................. 63
CONNECTING THE CAMERA TO
OTHER DEVICES ......................... 64
CAMERA SPECIFICATIONS........ 65
E
7
INTRODUCTION
Overview
This camera is a friendly-interface digital still camera, which delivers outstanding 2048x1536 image
resolution and high quality with a 3.3 Mega pixels, 1/2.51" CCD. By using the equipped 1.5" TFT LCD
monitor, you can compose pictures and examine them in detail. An auto-flash sensor, which automati-
cally detects the shooting conditions and determines whether the flash should be used, helps ensure
that your pictures turn out right. The 16MB built-in memory lets you record or store images without
purchasing an additional memory card. Or you can expand the memory capacity (up to 128MB capacity)
by using an external memory card. Besides the still images, you can record moving images with the
provided movie function.
E
Pictures you have taken can be easily downloaded to your computer without an effort by the supplied
USB cable and USB driver (for Win98 and Mac OS 8.6). You can enhance and retouch your pictures on
your computer by using the provided editing software before sharing them with your friends via e-mail.
The DPOF-supported function allows you to print out your images from the compatible printers by
simply inserting the memory card. All the thoughtful functions are specially designed for you. Now let’s
guide you to experience the benefits this camera offered.
8