AB1562 Product Brief
BENEFITS
applications
filter
drivers
Low power consumption for BT audio
PRODUCT OVERVIEW
BT RF with on-chip balun and band pass
The AB1562 series, intended for Bluetooth audio applications, integrates the PMU, DSP, BT, and audio functions
into a single chip. The Tensilica HiFi Mini DSP is a general processor and used for audio data processing. The
Bluetooth RF, integrating the balun and the band pass filter, provides good TX/RX performance. High
performance audio drivers and hardware active noise cancellation circuits are also included for better audio
quality.
In addition, the power management IC (PMIC) with fast charging is SiP(system-in-package) in the package to
shorten the battery charging time. The flash memory are also SiP for easier PCB design.
FOR bozzy@ szdotop.com USE ONLY
AIROHA CONFIDENTIAL
Wireless earbuds
Voice assistants
TARGET APPLICATIONS
High efficient low quiescent current Buck
components
System in Package (SiP) flash
High performance high quality audio
© 2020 Airoha Technology Corp.
loginid=bozzy@szdotop.com,time=2020-04-03 15:06:33,ip=113.89.41.164,doctitle=AB1562_Product_Brief.docx,company=
Clock GenerationAudio InterfaceFLASH Power Management IC PeripheralsVBATXTALOn-ChipMemoryTensilica HiFi Mini DSPBluetooth RF Bluetooth BasebandUARTI2CCap TouchSpeakersMicrophones
Memory
speed 104MHz
Platform
FEATURES
Host and DSP processor
o Power Path Management
Power management
with high hit rate and zero wait state
SiP 16Mb low-power flash with maximum
sampling rate converter
Hardware Active Noise Cancellation (ANC)
Three uplink paths with analog/digital
microphone input mode. The maximum
sample rate is 192 KHz.
One downlink path with maximum 192 KHz
Hardware gain control
I2S master or slave modes
o Feedforward ANC
o Hybrid ANC (only AB1562A support)
Cadence® HiFi Mini Audio Engine DSP
coprocessor with HiFi EP® extension
Maximum speed: 208MHz
32kB instruction cache and 8kB data cache
Class D amplifier
Side-tone filter
Two channel memory-based asynchronous
160kB instruction RAM with zero wait state
384kB data RAM with zero wait state
Execute In Place (XIP) on flash memory
Wide Li+ battery voltage from 2.8V to 5V
Low quiescent 2 buck converters and 3 LDOs
Linear Battery Charger
Dynamic Frequency Scaling (DFS)
RTC timer
General purpose timers (GPTs)
Watchdog timer (WDT)
Ambient temperature from -40°C to 85°C
FOR bozzy@ szdotop.com USE ONLY
AIROHA CONFIDENTIAL
UART interfaces up to 3Mbps
SPI master interface up to 52MHz
12-bit AUXADC channels
PWM channels
Capacitive Touch
Current sink driver (ISINK)
Support for power key and reset function
Support for hardware long press shutdown
Over-current and thermal overload protection
Under voltage lockout protection
linearity and high order channel filter
Integrated T/R switch and balun
Fully integrated PA provides 8dBm output
Baseband support for dual mode (Bluetooth
and Bluetooth LE) and isochronous channel
power
-94dBm sensitivity with interference rejection
performance
QFN of 4.0mm*6.5mm, 44-pin, 0.4mm pitch
Fully compliant with Bluetooth core
specification 5.1
Low-IF architecture with high degree of
Package
Peripheral
I2C interfaces up to 3.4Mhz
Bluetooth
AB1562 Product Brief
Audio
sample rate.
Support for BLE1M/2M
© 2020 Airoha Technology Corp.
loginid=bozzy@szdotop.com,time=2020-04-03 15:06:33,ip=113.89.41.164,doctitle=AB1562_Product_Brief.docx,company=