logo资料库

ECS精英主板-H61H2-M3说明书.pdf

第1页 / 共70页
第2页 / 共70页
第3页 / 共70页
第4页 / 共70页
第5页 / 共70页
第6页 / 共70页
第7页 / 共70页
第8页 / 共70页
资料共70页,剩余部分请下载后查看
Preface Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. Version 1.0C Disclaimer The information in this document is subject to change without notice. The manufac- turer makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. The manufacturer reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation of the manufacturer to notify any person of such revision or changes. Trademark Recognition Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp. MMX, Pentium, Pentium-II, Pentium-III, Celeron are registered trademarks of Intel Corporation. Other product names used in this manual are the properties of their respective owners and are acknowledged. Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter- ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver Connect the equipment onto an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to ensure compliance with the pertinent RF emission limits governing this device. Changes or modifications not expressly approved by the system’s manu- facturer could void the user’s authority to operate the equipment. Preface
ii Declaration of Conformity This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: • • This device may not cause harmful interference. This device must accept any interference received, including interfer- ence that may cause undesired operation. Canadian Department of Communications This class B digital apparatus meets all requirements of the Canadian Interference- causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilieur du Canada. About the Manual The manual consists of the following: Chapter 1 Introducing the Motherboard Chapter 2 Installing the Motherboard Chapter 3 Using BIOS Chapter 4 Using the Motherboard Software Chapter 5 Trouble Shooting Describes features of the motherboard. Go to page 1 Describes installation of motherboard components. Go to page 9 Provides information on using the BIOS Setup Utility. Go to page 27 Describes the motherboard software Go to page 59 Provides basic trouble shoot- ing tips Go to page 63 Preface
TTTTTABLE OF CONTENTS ABLE OF CONTENTS ABLE OF CONTENTS ABLE OF CONTENTS ABLE OF CONTENTS iii Preface i 1 Chapter 1 Introducing the Motherboard 1 Introduction...................................................................................1 Feature............................................................................................2 Specifications................................................................................4 Motherboard Components..........................................................6 9 9 9 9 9 Chapter 2 Installing the Motherboard 9 Safety Precautions............................................................................9 Choosing a Computer Case.............................................................9 Installing the Motherboard in a Case............................................9 Checking Jumper Settings.............................................................10 Setting Jumpers......................................................................10 Checking Jumper Settings......................................................11 Jumper Settings......................................................................11 Installing Hardware...................................................................12 Installing the Processor..........................................................12 Installing Memory Modules...................................................14 Expansion Slots......................................................................16 Connecting Optional Devices.................................................18 Installing a SATA Hard Drive................................................21 Connecting I/O Devices............................................................... 22 Connecting Case Components.....................................................23 Front Panel Header................................................................26 Chapter 3 Using BIOS 27 27 About the Setup Utility........................ ......................................... 27 The Standard Configuration........................ ...........................27 Entering the Setup Utilities......................................................27 Resetting the Default CMOS Values....................................28 Using BIOS......................................................................................28 BIOS Navigation Key.............................................................29 Main Menu.............................................................................30 Advanced Menu......................................................................31 Chipset Menu..........................................................................40 M.I.B.III(MB Intelligent Bios III) Menu..................................47 Boot Menu...............................................................................52
iv Security Menu.........................................................................54 Exit Menu...............................................................................57 Updating the BIOS..................................................................58 Chapter 4 Using the Motherboard Software 59 59 59 59 59 59 Auto-installing under Windows XP/7/8.......................................59 Running Setup.........................................................................59 Manual Installation...........................................................................61 ECS Utility Software ........................................................................61 Chapter 5 Trouble Shooting 63 63 63 63 63 63 Start up problems during assembly..............................................63 Start up problems after prolong use............................................64 Maintenance and care tips..............................................................64 Basic Troubleshooting Flowchart...................................................65
1 Chapter 1 Introducing the Motherboard Introduction Thank you for choosing the H61H2-M3 motherboard. This motherboard is a high performance, enhanced function motherboard designed to support the LGA1155 socket for latest Intel® CoreTM Family/ Pentium® / Celeron® processors*1. This motherboard is based on Intel® H61 Chipset for best desktop platform solution. H61 is a single-chip, highly integrated, high performance Hyper-Threading periph- eral controller, unmatched by any other single chip-device controller. This motherboard supports up to 8 GB of system memory with dual channel DDR3 1333/ 1066 SDRAM. Two PCI are supported, fully compliant with PCI rev 2.2 specifica- tion at 33MHz. High resolution graphics via PCI Express x16 slot, intended for Graphics Interface, is fully compliant to the PCI Express Base Specification revision 2.0. In addition, one PCI Express slot is supported. It implements an EHCI (En- hanced Host Controller Interface) compliant interface that provides ten USB 2.0 ports (six USB 2.0 ports at the back panel and two USB 2.0 headers support addi- tional four USB 2.0 ports). The gray USB 2.0 header provides EZ charger technol- ogy, please reference chapter 2 parts of Front Panel USB headers to check the detail information. H61H2-M3 implements optional USB 3.0 chip which provides two optional USB 3.0 ports*2 at rear I/O with blue connectors also. The motherboard is equipped with advanced full set of I/O ports in the rear panel, including PS/2 mouse and PS/2 keyboard connectors, one DVI (co-lay HDMI) port, one D_sub (VGA) port, one Lan port, six USB 2.0 ports, which includes two USB ports with optional USB 3.0 specification running at 5 Gb/s, and audio jacks for microphone, line-in and line-out. In addition, this motherboard supports four SATA 3Gb/s connectors for expansion. *1 When accommodating Intel 3rd Generation CPU, the PCI Express 16X slot can run at Gen3 speed, which accelerates on 32GB/s rate that effectively delivers double of PCI Express Gen2 speed. *2-1 The USB 3.0 connectors are optimized for SuperSpeed USB 3.0 devices, aslo are fully backwards-compatible with Hi-Speed USB 2.0 de- vices. *2-2 The USB 3.0 connectors are optional, please refer to the detail informa- tion in page 22 and take the object as the standard. Introducing the Motherboard
2 Feature Processor The motherboard uses an LGA1155 type of socket that carries the following features: • Accommodates the LGA1155 socket for latest Intel® CoreTM Family/ Pentium® / Celeron® processors. Supports “Hyper-Threading” technology CPU One PCI Express x16 Gen2 port supporting up to 5 GB/s direction peak bandwidth “Hyper-Threading” technology enables the operating system into thinking it’s hooked up to two processors, allowing two threads to be run in parallel, both on separate “logical” processors within the same physical processor. Chipset The Intel H61 Chipset is a single-chip with proven reliability and performance. • • • • • • Support one PCI Express slot Integrated four SATA 3.0 Gb/s Host Controller Ten USB 2.0 ports supported Serial Peripheral Interface (SPI) support Integrated Graphics Support with PAVP 1.5 Intel® High Definition Audio Controller Extra Chips • ITE IT8893 PCI Bridge supports two PCI slots expansion • • • • Memory • Supports DDR3 1333/1066 DDR3 SDRAM with Dual-channel architec- ture Accommodates two unbuffered DIMMs Up to 4 GB per DIMM with maximum memory size up to 8 GB Audio • • • • • • 5.1+2 Channel High Definition Audio Codec Meets Microsoft WLP3.x (Windows Logo Program) audio requirements All DACs supports 44.1k/48k/96k/192kHz sample rate Software selectable 2.5V/3.2V/4.0V VREFOUT Direct Sound 3D. compatible Power Support: Digital: 3.3V; Analog: 5.0V Introducing the Motherboard
3 Onboard LAN (Optional) The onboard LAN provides the following features: • • • • • • Supports PCI ExpressTM 1.1 Integrated 10/100/1000 transceiver Wake-on-LAN and remote wake-up support Supports PCI ExpressTM 1.1 Integrated 10/100 transceiver Wake-on-LAN and remote wake-up support Expansion Options The motherboard comes with the following expansion options: • • • • One PCI Express x16 slot for Graphic Interface One PCI Express slot Two 32-bit PCI v2.2 compliant slots Four SATA connectors Integrated I/O The motherboard has a full set of I/O ports and connectors: • • • • • • One LAN port One D-sub (VGA) port One DVI port ( HDMI Port optional) Six USB 2.0 ports (including two USB ports with optional USB 3.0* specification running at 5 Gb/s.) One PS/2 keyboard and PS/2 mouse connectors Audio jacks for microphone, line-in and 6-ch line-out *The USB 3.0 connectors are optional, please refer to the detail informa- tion in page 22 and take the object as the standard. BIOS Firmware This motherboard uses AMI BIOS that enables users to configure many system features including the following: • • • • • Power management Wake-up alarms CPU parameters CPU and memory timing Graphic parameters The firmware can also be used to set parameters for different processor clock speeds. 1. Some hardware specifications and software items are subject to change without prior notice. 2. Due to chipset limitation, we recommend that motherboard be operated in the ambiance between 0 and 50 ° C. Introducing the Motherboard
4 Specifications CPU • Chipset Extra Chips Memory Expansion Slots Storage Audio LAN Rear Panel I/O Internal I/O Connectors & Headers • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • LGA1155 socket for latest Intel® CoreTM Family/ Pentium® / Celeron® processors Supports “Hyper-Threading” technology CPU Intel® H61 Chipset ITE IT8893 PCI Bridge supports two PCI slots expansion Dual-channel DDR3 memory architecture 2 x 240-pin DDR3 DIMM sockets support up to 8 GB Supports 1333/1066 DDR3 SDRAM 1 x PCI Express x16 Gen2 slot 1 x PCI Express slot 2 x PCI slots Supported by Intel® H61 Express Chipset -4 x Serial ATA 3.0 Gb/s Host Controllers Realtek ALC662 6-Ch HD audio CODEC Compliant with HD audio specification Realteck RTL8105E Lan (Co-lay RTL 8111E Gigabit Lan ) 6 x USB 2.0 ports (including 2 x USB ports with optional USB 3.0 specification running at 5 Gb/s) 1 x DVI port (HDMI port optional) 1 x VGA port 1 x RJ45 LAN connector 1 x PS/2 keyboard & PS/2 mouse connectors 1 x Audio port (Line in, microphone in, 6-ch line out) 1 x 24-pin ATX Power Supply connector 1 x 4-pin ATX Power Supply connector 1 x 4-pin CPU_FAN connector 1 x 3-pin SYS_FAN connector 4 x Serial SATA 3.0 Gb/s connectors 1 x Front panel switch/LED header 1 x Front panel audio header 2 x USB 2.0 headers support additional four USB 2.0 ports (F_USB1 supports EZ charger) 1 x Case Open header 1 x COM header 1 x SPDIF out header 1 x SPK header 1 x Clear CMOS header Introducing the Motherboard
分享到:
收藏