logo资料库

Traveler数码相机-Traveler DC-5600说明书.pdf

第1页 / 共75页
第2页 / 共75页
第3页 / 共75页
第4页 / 共75页
第5页 / 共75页
第6页 / 共75页
第7页 / 共75页
第8页 / 共75页
资料共75页,剩余部分请下载后查看
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. EN-1
READ THIS FIRST Trademark Information Microsoft® and Windows® are U.S. registered trademarks of Microsoft Corporation. Pentium® is a registered trademark of Intel Corporation. Macintosh is a trademark of Apple Computer, Inc. SDTM is a trademark. Photo Explorer and Photo Express are trademarks. Other names and products may be trademarks or registered trademarks of their respective owners. Product Information Product design and specifications are subject to change without notice. This includes primary product specifications, software, software drivers, and user’s manual. This User Manual is a general reference guide for the product. The product and accessories that come with your digital camera may be different from those described in this manual. This is due to the fact that different retailers often specify slightly different product inclusions and accessories to suit their market requirements, customer demographics, and geographical preferences. Products very often vary between retailers especially with accessories such as batteries, chargers, AC adapters, memory cards, cables, carrying cases/pouches, and language support. Occasionally a retailer will specify a unique product color, appearance, and internal memory capacity. Contact your dealer for precise product definition and included accessories. The illustrations in this manual are for the purpose of explanation and may differ from the actual design of your digital camera. The manufacturer assumes no liability for any errors or discrepancies in this user manual. For user manual and driver updates, refer to our website or contact your dealer. EN-2
SAFETY INSTRUCTIONS Read and understand all Warnings and Cautions before using this product. Warnings If foreign objects or water have entered the camera, turn the power OFF and remove the batteries and the AC power adapter. Continued use in this state might cause fire or electric shock. Consult the store of purchase. If the camera has fallen or its case has been damaged, turn the power OFF and remove the batteries and the AC power adapter. Continued use in this state might cause fire or electric shock. Consult the store of purchase. Do not disassemble, change or repair the camera. This might cause fire or electric shock. For repair or internal inspection, ask the store of purchase. Use the supplied AC adapter only with the indicated power supply voltage. Use with any other power supply voltage might cause fire or electric shock. Do not use the camera in areas near water. This might cause fire or electric shock. Take special care during rain, snow, on the beach, or near the shore. Do not place the camera on inclined or unstable surfaces. This might cause the camera to fall or tilt over, causing injury. Keep the batteries out of the reach of children. Swallowing batteries might cause poisoning. If the battery is accidentally swallowed, immediately consult a physician. Do not use the camera while you are walking, driving or riding a motorcycle. This might cause you to fall over or result in traffic accident. EN-3
Cautions Insert the batteries paying careful attention to the polarity (+ or –) of the terminals. Inserting the batteries with its polarities inverted might cause fire and injury, or damage to the surrounding areas due to the battery rupturing or leaking. Do not fire the flash close to anyone’s eyes. This might cause damage to the person’s eyesight. Do not subject the LCD monitor to impact. This might damage the glass on the screen or cause the internal fluid to leak. If the internal fluid enters your eyes or comes into contact with your body or clothes, rinse with fresh water. If the internal fluid has entered your eyes, consult a physician to receive treatment. A camera is a precision instrument. Do not drop it, strike it or use excessive force when handling the camera. This might cause damage to the camera. Do not use the camera in humid, steamy, smoky, or dusty places. This might cause fire or electric shock. Do not remove the battery immediately after long period of continuous use. The battery becomes hot during use. Touching a hot battery might cause burns. Do not wrap the camera or place it in cloth or blankets. This might cause heat to build up and deform the case, resulting in fire. Use the camera in a well-ventilated place. Do not leave the camera in places where the temperature may rise significantly, such as inside a car. This might adversely affect the case or the parts inside, resulting in fire. Before you move the camera, disconnect cords and cables. Failure to do this might damage cords and cables, resulting in fire and electric shock. EN-4
Notes on Battery Usage When you use the battery, carefully read and strictly observe the Safety Instructions and the notes described below: Different battery types and surrounding temperatures may affect the battery performance. Avoid using batteries in extremely cold environments as low temperatures can shorten the battery life and reduce camera performance. This low temperature will also influence Alkaline battery performance, therefore Ni-MH rechargeable battery is highly recommended. If you are using the new rechargeable batteries or rechargeable batteries that have not been used for an extended period of time (batteries that pass the expiry date are exceptions) might affect the number of pictures that can be taken. Therefore, to maximize their performance and lifetime, we recommend that you fully charge the batteries and discharge them for at least one complete cycle before use. The battery may feel warm when using the camera for an extended period of time or using the flash continuously. This is normal and not a malfunction. The camera may feel warm when being used continuously or for an extended period of time. This is normal and not a malfunction. If you will not be using the batteries for an extended period of time, remove them from the camera to prevent leakage or corrosion. Never use batteries of different types (together) or mix old and new batteries. Always keep the terminals in a clean state. Never use manganese batteries. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. EN-5
CONTENTS INTRODUCTION ................................................ 8 Package Contents............................................ 9 GETTING TO KNOW YOUR CAMERA.............. 10 Front View...................................................... 10 Rear View......................................................... 11 Mode Dial ...................................................... 12 LCD Monitor Information..................................... 13 PREPARING THE CAMERA............................. 15 Installing the Batteries...................................... 15 Using the AC Power Adapter..............................16 Inserting and Removing an SD Memory Card .........17 Attaching the Camera Strap.............................. 18 LED Indicators..................................................18 GETTING STARTED........................................... 19 Turning the Power On/Off ................................. 19 Choosing the Screen Language......................... 19 Setting the Date and Time ................................20 Formatting an SD Memory Card or Internal Memory............................................................ 21 Using the LCD Monitor....................................... 22 EN-6 PHOTOGRAPHY MODE................................... 23 Shooting Images - The Basics..........................23 Setting Image Resolution and Quality ................ 24 Using the Zoom Function................................... 26 Using the Flash............................................... 27 Using the Self-Timer......................................... 28 Adjusting the Exposure (EV Compensation)......... 29 Setting White Balance...................................... 30 USING THE MODE DIAL.................................... 31 Auto Mode......................................................31 Program Mode ............................................... 31 Portrait Mode.................................................. 32 Landscape Mode.............................................. 32 Sport Mode.....................................................33 Night Mode..................................................... 33 ADVANCED SHOOTING................................... 34 Burst.............................................................. 34 Auto Exposure Bracketing (AEB) ...................... 35 Selecting the Metering Mode ............................. 36
PLAYBACK MODE - THE BASICS..................... 37 Viewing Images ............................................... 37 Magnifying Images .......................................... 38 Thumbnail Display .......................................... 39 Slideshow Display ........................................... 40 Resizing an Image ........................................... 41 VIDEO MODE.................................................... 42 Recording Video Clips ...................................... 42 Playing Back Video Clips ................................. 43 PLAYBACK MODE – ADVANCED FEATURES...44 Playing Back Still Images/Video Clips on TV ........ 44 Deleting Images/Video Clips.............................. 45 Protecting Images/Video Clips ........................... 46 Setting the DPOF............................................. 47 Connecting to a PictBridge Compliant Printer (Optional Function).......................................... 49 TRANSFERRING FILES FROM YOUR DIGITAL CAMERA TO COMPUTER.................................53 Step 1: Install the USB driver .........................54 Step 2: Connect the digital camera to your computer...........................................55 Step 3: Download images or video clips............56 EDITING SOFTWARE INSTALLATION..............57 Installing Photo Explorer....................................57 Installing Photo Express....................................58 USING THE DIGITAL CAMERA AS A PC CAMERA...59 Install the PC camera driver..................59 Step 1: Step 2: Connect the digital camera to your Step 3: computer.............................................60 Run your application software (i.e. Windows NetMeeting)....................60 MENU OPTIONS...............................................61 Camera Menu.................................................... 61 Video Menu ................................................... 65 Playback Menu............................................... 66 Setup Menu.................................................... 68 CONNECTING THE DIGITAL CAMERA TO OTHER DEVICES............................................. 71 SPECIFICATIONS............................................ 72 APPENDIX........................................................ 73 EN-7
INTRODUCTION Thank you for purchasing the new digital camera! Equipped with a 5.0 Megapixels CCD sensor, your camera delivers good quality, 2560 x 1920 resolution images. Other features provided by the camera include the following: 5.0 Megapixels A high-resolution CCD sensor provides 5.0 megapixels for good quality of images. Auto flash An auto flash sensor automatically detects the shooting (lightening) conditions and determines whether the flash should be used. 2.0” LTPS color image LCD monitor Optical zoom: 1x~3x Digital zoom: 1x~4x 12MB internal (built-in) memory Images can be captured without using a memory card. Support for SD memory card for memory expansion You may wish to expand the memory capacity (up to 512MB capacity) by using an external memory card. USB connection (USB 1.1 compliant) Still images, video clips, or voice recording files that you have recorded can be downloaded to your computer using the USB cable (A USB driver is required for Win 98 and Win98SE). DPOF functionality DPOF can be used to print your images on a DPOF compatible printer by simply inserting the memory card. PictBridge support You can connect the camera directly to printer that supports PictBridge and perform image selection and printing using the camera monitor screen and controls. Provided editing software: Photo Explorer / Photo Express You can enhance and retouch your images on your computer by using the provided editing software. EN-8
分享到:
收藏